Whether the installation of stainless steel sanitary valves is correct or not will be linked to the quality

Dec 19, 2022|

Stainless steel sanitary valves refer to valves made of stainless steel, which are clean and pollution-free, and are often used in pharmaceutical, food and other industries. Sanitary valves have very high requirements for sanitation from production to use. The material of the valve is mostly high-grade stainless steel 316L as the main material of the valve body, and most of the manufacturers purchased are pharmaceutical or food factories.

Precautions for Sanitary Valve Installation

1. Before installing the sanitary valve, it is necessary to confirm that the sanitary valve meets the design requirements and relevant standards.

2. When moving and installing sanitary valves, beware of accidents caused by bumps and scratches.

3. Before installing the sanitary valve, the inside of the pipeline should be cleaned to remove impurities such as iron filings to prevent the sealing seat of the sanitary valve from being mixed with foreign matter. In addition, the sanitary valve should be closed during installation.

4. When lifting the valve. Sanitary valves must be hoisted correctly at specific lifting positions, and sanitary valves must not be lifted or towed only under local stress.

5. When installing sanitary valves, it is necessary to confirm whether the flow direction of the medium, the installation form and the position of the handwheel comply with the regulations.

The quality of the stainless steel sanitary valve during installation will directly affect its service life, so it must be taken seriously and carefully follow the instructions for installation.

Be careful during installation and construction, and avoid hitting valves made of brittle materials.

When lifting the valve, it is best not to tie the rope to the handwheel or the valve stem, so as not to damage these parts, and it is better to tie it to the flange.

The pipeline connected to the valve must be cleaned. This compresses the air and blows away iron oxide chips, mud sand, welding slag and other debris. Because these debris can easily scratch the sealing surface of the valve, and the large particles of debris may directly block the small valve, making it ineffective.

When installing flanged pneumatic valves, you need to pay more attention to symmetry and evenness before tightening the bolts. The flange of the valve must be parallel to the flange of the pipe, and the gap needs to be reasonable, so that the valve may generate excessive pressure and crack. Special attention is required for brittle materials and low-strength sanitary valves. Certain valves welded with pipes need to be spot welded first, then fully open the closing parts, and then weld them dead.

When installing a stainless steel sanitary valve with a screw port, the packing (line hemp plus lead oil or Teflon raw material tape) should be sealed first, and then wrapped on the thread of the pipe. Do not get it in the valve to avoid There is an internal volume in the valve, which affects the flow of the medium.


Send Inquiry