What are the steps for installing sanitary ball valves?
Apr 02, 2024| The steps for installing sanitary ball valves are as follows:
1. It is necessary to remove the protective cover on both sides of the flange end, and then rinse and clean the valve body of the sanitary grade ball valve when it is opened.
2, before installation, the whole machine must be tested according to the specified signal, and the on-line installation can be carried out after passing.
3, in preparation for the revolutionary pipeline connection, you must first rinse and remove the remaining impurities in the clean pipeline.
4, during the installation, do not use the actuator part of the ball valve as the lifting point to prevent damage to the actuator and accessories.
5. Sanitary ball valve This type of valve should be installed in the horizontal direction or vertical direction of the pipeline.
6, after connecting with the pipe, you can use the specified torque to cross to lock the flange and connect the bolts.
7. The pipe near the installation point of the stainless steel ball valve can not have a low hanging or bear the phenomenon of external force, and we can use pipe supports or supports to remove the deviation of the pipeline.
Sanitary ball valve is one of the valves, sanitary ball valve in the pipeline is mainly used to cut off or connect the medium in the pipeline. When we install the sanitary ball valve, we all need to install and use our ball valve according to the above steps.