Seven Steps For Quick Installation Of A Sanitary Ball Valve
Aug 23, 2021| Seven steps for quick installation of a sanitary ball valve
1, it is necessary to remove the protective cover on both sides of the flange end, and then wash and clean the valve body of the sanitary valve when it is fully opened.
2, before installation, the whole machine must be tested according to the specified signal, and can be installed online after passing the test.
3, in the preparation of the revolution pipeline connection, must first flush and clean the remaining impurities in the pipeline.
4, during the installation, do not use the actuator part of the ball valve as the lifting lifting point, in order to prevent damage to the actuator and accessories.
5.This kind of valve should be installed in the horizontal direction or vertical direction of the pipeline.
6. the pipe near the installation point of stainless steel ball valve can not have low or bear the phenomenon of external force, you can use pipe support or support to eliminate the deviation of the pipeline.
7. After connecting with the pipe, the flange can be crossed to lock and the bolt can be connected using the specified torque.