Plug Valve Seal Strength Testing Equipment hyphen Water Pressure Test Bench For Globe Valve
Oct 10, 2019| One product introduction
Plug valve seal strength testing equipment - cut-off valve, hydraulic pressure test rig test pressure of 40 mpa reference standard GB/T1, 3927-92, the common valve pressure test, ZBJI6006-90 developed by the test of the valve and the testing, pressure testing process by hydraulic drive, electric control, the valve is to be measured without any additional influences the test result of external force, is widely applied in nominal diameter DN15 - DN400mm straight-through flange structure, high, medium and low pressure gate valve, ball valve, globe valve, check valve and plug valve and valve seal box strength, etc. Various performance tests,Widely used in quality testing units, product quality monitoring stations, scientific research institutions and other valve production, development and research fields.Can greatly improve work efficiency and reduce labor force, is the valve manufacturing industry use, maintenance and other units of an advanced ideal valve testing and testing equipment.
Plug valve sealing strength testing equipment - cut-off valve water pressure withstand test bed characteristics
(1) equipped with wenhan booster pump can carry out a variety of pressure tests, can adjust the pressure.
(2) equipped with control device, the output pressure and time can be easily adjustable and controllable.
(3) with power failure protection function, the system will automatically relieve pressure and terminate the test after power failure, * limit to ensure the safety of operators and equipment.
(4) the pressurization can be automatically stopped by stages to a certain pressure.The test time can be counted down automatically and the end of time is reminded.
(5) manual control and computer control can be selected according to needs.
(6) data processing and analysis by microcomputer can be carried out, and the experimental results can be automatically saved. After the end of the experiment, the experimental curve can be jumped out again, and the test process can be reproduced through the curve traversal, or curve comparison, curve amplification, etc..
(7) advanced control principle, accurate control of pressure accuracy, good pressure holding effect, real-time automatic pressure compensation.Test process according to customer needs to set, friendly interface.
Plug valve seal strength testing equipment - cut-off valve water pressure withstand test bed basic parameters
(1) working medium: water, oil and emulsion
(2) flow rate of pneumatic air source: 0.8-1m3/min
(3) driving pressure range: 0-40mpa
(4) data recording: manual and computer.
(5) test time: 0-100h
(6) test temperature: normal temperature
Five typical applications
Hydraulic seal test for gate, ball, globe, check and plug valves